Myweigh Flipscale F2 Instrukcja Użytkownika Pobierz pdf

Flipscale F2 Owner's Manual

Low Batteries & bad battery connections are the #1 cause of scale malfunction and inaccuracy! We test

all of our scale returns from consumers. Fully 60% of consumer returns are battery related problems.

This sounds silly but it's true! A scale will perform slowly, or read inaccurately when it has low batteries.

Please replace the batteries often (and only use good quality batteries). We include good quality

batteries with all of our scales but batteries can run low in storage. If your scale simply won't turn on

while on Battery power, this is often caused by loose battery connections. Battery prongs (terminals) are

made of metal. They must be making good contact with your batteries in order for the scale to power

on. You can use a paperclip to slightly bend the battery prongs to make them have a better connection.

Also some poorly designed batteries have recessed or partially obstructed battery terminals. This may

cause your prongs to be touching the plastic housing of the battery instead of the metal battery

terminal.

FLIPSCALE TROUBLESHOOTING & OPERATION NOTES:

1) If the Display ever becomes locked showing "Out2", please recalibrate the scale as outlined in the

manual

2) If the Display ever becomes locked on LLLLL, or EEEEE, this indicates that the scale was shocked,

dropped or otherwise damaged and the delicate weighing sensors have been damaged. You can try

recalibrating the scale (If the sensor has not been hurt too badly it will work again after recalibration).

Otherwise you will have to follow the warranty instructions that came with your scale.

3) If the display becomes locked on 8888, this often indicates low batteries. However sometimes it also

may indicate a serious zero mark error. This means when you turn the scale on, it can't determine what

zero is (a slight zero mark error will cause situation #2 above) Thus, if new batteries do not fix this error

the scale will have to be sent to us for replacement under our warranty program.

4) If the display shows UNST, this means the scale is not stable. Please try operating the scale on a more

stable surface and be sure nothing is on the tray or stuck under the tray when you turn it on. If this

situation persists, it may be an indication of fatal load cell damage. Try calibrating the scale - if this does

not work please follow the warranty instructions.

1 2 3 4 5 6

Podsumowanie treści

Strona 1

Flipscale F2 Owner's Manual Low Batteries & bad battery connections are the #1 cause of scale malfunction and inaccuracy! We test all of ou

Strona 2

5) If the display appears “fuzzy” or unclear, try viewing the display from a different angle. We set the LCD display for maximum viewability, but from

Strona 3

* Handle with care. Gently apply all items to be weighed onto tray top. Although this scale is designed to be quite durable, avoid rough treatment as

Strona 4

Important: Always perform calibration procedure after first turning the unit on and allowing it to warm up and stabilize for 20 seconds. If possible p

Strona 5

Stable Reading Indication: This is a very precise scale - the display may seem to wander or jump when weighing. This is due to air currents or vibrati

Strona 6

key to turn the scale off * Z/T Press Zero to reset the scale to zero. This can be used for eliminating from a sample (or a Tray/Container) the weight

Komentarze do niniejszej Instrukcji

Brak uwag

Myweigh Flipscale F2 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Waga Myweigh Flipscale F2. MyWeigh Flipscale F2 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Waga Myweigh Flipscale F2